To adjust the offset, proceed as follows:

1. Remove the comb in accordance with the main instructions.
2. Loosen the two set screws at each end of the aluminum bar. (One half turn will be plenty.)
3. Front adjustment: Move the aluminum bar right or left as required and tighten the set screws. Use the phillips head screws on each side of the bar as a reference point to tell how far you've moved the aluminum bar.
4. Rear Adjustment: Loosen the set screw in the top of the vertical post on the recoil pad assembly and move left or right to line up with the front adjustment. Please note: if you move the front and rear adjustment over by differing amounts the sliding comb may bind. Re-tighten set screws.
5. Replace comb.